StewMac SM5435 fret slot depth gauge

fret slot depth   Dan fret slot width

Removable clear acrylic depth stop to precisely set any fret slot depth Our most efficient saw for fret slots! Handmade, each saw cuts on the pull-stroke

Perspex Fret Slotting Saw depth guide With brass thumbscrews to fit the Tonetech fret slotting saw Depth is adjustable from 1mm to 6mm The guide is made Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck

warganet slot Thanks for the reply Fret slot depth should conform to the curve of the top of fretboard, remaining a constant depth approx 3mm Top The standard is mm for regular frets and mm for replacement frets You can use a carpenter's square to guide your fret saw (use the straight side of