Using Your Router to Cut Dado Joints

Then use the calipers to measure the width You will most likely find that your bit is actually 249 wide, which will result in the dado slot

Using Your Router to Cut Dado Joints Dado Slot is on Facebook Join Facebook to connect with Dado Slot and others you may know Facebook gives people the power to share and makes the world

Then use the calipers to measure the width You will most likely find that your bit is actually 249 wide, which will result in the dado slot

slot crazy casino Yesterday I cut a dadoslot in the backboard I wasn't sure I would do it right but the end result is what I need

The problem is likely not your Dado set if it's a good quality, undamaged, and sharp model Check to make sure that the table saw miter slots

dado slot I'd cut the slot long enough to be able to start the router bit outside the material and a little narrow, run a test cut, and slowly make it

Since most ply vary in thickness, I would suggest that you under cut the dado slot using a 58 dado bit and then rabbet the plywood to match